before drilling
a taper punch
Engineering, 10.01.2020 02:31 live4dramaoy0yf9
1. select the punch that is used to make a mark in metal
before drilling
a taper punch
b. pin punch
oc. diamond point punch
d. center punch
Answers: 1
Another question on Engineering
Engineering, 03.07.2019 14:10
Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.
Answers: 1
Engineering, 04.07.2019 18:10
Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.
Answers: 1
Engineering, 04.07.2019 18:10
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
You know the right answer?
1. select the punch that is used to make a mark in metal
before drilling
a taper punch
before drilling
a taper punch
Questions
Physics, 25.05.2021 16:40
Mathematics, 25.05.2021 16:40
Chemistry, 25.05.2021 16:40
Mathematics, 25.05.2021 16:40
Mathematics, 25.05.2021 16:40
Mathematics, 25.05.2021 16:40
Biology, 25.05.2021 16:40
Biology, 25.05.2021 16:40
Arts, 25.05.2021 16:40
Geography, 25.05.2021 16:40
