Engineering, 27.12.2019 05:31 ericavasquez824

Apipe with closed ends has a wall thickness of 10 mm and an inner diameter of 0.60 m. it filled with a gas at 20 mpa pressure and subjected to a torque about its long axis of 1200 kn·m. a. determine the three principal normal stresses and the maximum shear stress. recall from basic mechanics that: = t / b. if the pipe is constructed of oil-quenched and tempered 4340 steel with a yield strength of 1620 mpa, what is the safety factor against yielding using the tresca maximum shear stress criterion? c. prior to loading, an inside crack is discovered through 25% of the thickness of the sample. with this crack, what is the safety factor against fracture if the plane strain fracture toughness is 87.4mpa√m?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

The drive force for diffusion is 7 fick's first law can be used to solve the non-steady state diffusion. a)-true b)-false

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?

Answers: 2

Answer

Engineering, 04.07.2019 18:20

A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.

Answers: 3

Answer

Engineering, 06.07.2019 05:10

An ideal vapour-compression heat pump cycle provides a heating rate of 12btu/s. the working fluid, refrigerant 134a, enters the compressor as a saturated vapor at 40 psi and exits the condenser as a saturated liquid at 160 psi. determine (a) the mass flow rate of the working fluid in lb/min (b) the compressor power in btu/min. (c) the coefficient of performance.

Answers: 2

Answer

You know the right answer?

Apipe with closed ends has a wall thickness of 10 mm and an inner diameter of 0.60 m. it filled with...

Questions