subject
Engineering, 21.12.2019 01:31 lrnnwb

Which of the following is the best definition of overflow?

a. when the sum is negative.
b. when the sum is negative and either operand is positive.
c. when there is a carry.
d. when there is a carry and one operand is positive and the other operand is negative.
e. when the correct result canā€™t be represented in the number of bits available

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40Ā°c and pl = 1 .2 mpa. water vapor att2-200Ā°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
question
Engineering, 04.07.2019 19:20
Acarnot refrigerator operates in a room in which the temperature is 21Ā°c and of power when operating. if the food compartment of the refrigerator is consumes 3 kw to be maintained at 2Ā°c, determine (a) the coefficient of performance of the cycle and (b) the rate of heat removal from the food compartment. refrigerator cycle that has a higher coefficient of performance than that of the discussed (e) is it possible to develop a carn ot refrigerator, operating between the same temperature limits? explain
Answers: 2
question
Engineering, 05.07.2019 10:10
What is the correct way to measure the overall length of a boat? measure from the tip of the bow to the highest point on the gunwale. measure from the tip of the bow in a straight line to the stern of the boat. measure from the tip of the bow in a straight line to the back seat. measure from port to starboard at the boat's widest point.
Answers: 1
question
Engineering, 06.07.2019 03:20
What is the strain energy stored in a solid uniformly circular shaft of length 3.0 m and diameter 120 mm when subject to pure torsion if the maximum shear stress is 40 mpa? g-80gpa
Answers: 1
You know the right answer?
Which of the following is the best definition of overflow?

a. when the sum is negative...
Questions
question
Advanced Placement (AP), 08.04.2022 20:30
Questions on the website: 13722362