Engineering, 21.12.2019 00:31 Danios

Alarge corporation owning an ip address range of 192.168.2.0/25 has its own isp. assume that an office building within the corporation using address range of 192.168.2.0/28 desires a connection with its own autonomous isp in addition to the connection with its corporation. the building is connected to corporation edge router r1 through its edge router r2, and is also connected to its own isp through r3. we would like to configure connecting routers according to bgp. (a) show the configuration of r1 and r2 and specifically demonstrate what r1 and r2 should advertise. (b) repeat part (a) when the building management decides to have its own independent network ip addresses. (c) show how routers should be configured if the corporation decides to use the building’s isp when it experiences slow bit rates during the peak traffic times.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

Answer

Engineering, 04.07.2019 03:10

What precautions should you take to prevent injuries when dealing with heavy loads?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

You know the right answer?

Alarge corporation owning an ip address range of 192.168.2.0/25 has its own isp. assume that an offi...

Questions