subject
Engineering, 20.12.2019 20:31 madeleine1102

Aswimming pool is 50 ft wide and 100 ft long and its bottom is an inclined plane, the shallow end having a depth of 4 ft and the deep end, 10 ft.

assume the pool is full of water. (round your answers to the nearest whole number. recall that the weight density of water is 62.5 lb/) estimate the hydrostatic force on the shallow end.(b) estimate the hydrostatic force on the deep end.(c) estimate the hydrostatic force on one of the sides.(d) estimate the hydrostatic force on the bottom of the pool.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
question
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
question
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
question
Engineering, 04.07.2019 18:20
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
You know the right answer?
Aswimming pool is 50 ft wide and 100 ft long and its bottom is an inclined plane, the shallow end ha...
Questions
question
English, 15.10.2020 20:01
question
Mathematics, 15.10.2020 20:01
question
Mathematics, 15.10.2020 20:01
question
Mathematics, 15.10.2020 20:01
question
Mathematics, 15.10.2020 20:01
question
Chemistry, 15.10.2020 20:01
question
Spanish, 15.10.2020 20:01
Questions on the website: 13722361