Engineering, 20.12.2019 02:31 zayy8595
An air-standard dual cycle has a compression ratio of 14 and a cutoff ratio of 1.2. the pressure ratio during the constant-volume heat addition process is 1.5. determine the thermal efficiency, amount of heat added, the maximum gas pressure and temperature when this cycle is operated at 80 kpa and 20°c at the beginning of the compression. use constant specific heats at room temperature.
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 15:10
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
Engineering, 04.07.2019 18:20
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
You know the right answer?
An air-standard dual cycle has a compression ratio of 14 and a cutoff ratio of 1.2. the pressure rat...
Questions
Mathematics, 01.07.2021 08:30
Physics, 01.07.2021 08:30
Mathematics, 01.07.2021 08:30
English, 01.07.2021 08:30
English, 01.07.2021 08:30
Mathematics, 01.07.2021 08:30
Mathematics, 01.07.2021 08:30
Mathematics, 01.07.2021 08:30
English, 01.07.2021 08:30
