Engineering, 19.12.2019 04:31 khikhi1705

Problem 12. the design of the gear and shaft system requires that steel shafts of the same diameter be used for both ab and cd. it is further required that ߬௠௔௫ ൑ 60 mpa, and that the angle ߶஽ through which end d of shaft cd rotates not exceed 1.5°. knowing that g=77.2 gpa, determine the required diameter of the shafts.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Inspection for bearing condition will include: (clo4) a)-color b)-smell c)-size d)-none of the above

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

Answer

You know the right answer?

Problem 12. the design of the gear and shaft system requires that steel shafts of the same diameter...

Questions