Engineering, 18.12.2019 17:31 tiaemrich146

Apinion 1 is driving a gear 3 (moderate shock machinery) through an idler 2. the lines between the centers of 1-2 and 3-2 make an angle of 135e. the diameter of the pinion is 4" and it has 24 teeth. the mounting is accurate with low clearances and high precision gears. the pinion is powered by a 20 hp uniform motor running at 400 rpm, in a direction that minimizes the force on the idler shaft. the idler has 32 teeth. the required speed of rotation of gear 3 is 300 rpm. all gears are full depth spur gears, precision shaved and ground, with a pressure angle of 25-deg, face width 2" and made from the same steel. assuming that the power losses are negligible: (a) what are the maximum bending stresses at the idler and pinion gears? (b) what is the required minimum material strength for a fatigue strength reliability of 98.7%? (c) what is the force on the idler shaft?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

Answer

Engineering, 04.07.2019 18:20

What is the heat treatment of metals? what is the benefit of it? why and how it's useful? answer in details, do not write by hand.

Answers: 3

Answer

You know the right answer?

Apinion 1 is driving a gear 3 (moderate shock machinery) through an idler 2. the lines between the c...

Questions