subject
Engineering, 18.12.2019 00:31 mathman783

Set up the following characteristic equations in the form suited to evans root-locus method. give l(s), a(s) and b(s) and the parameter k in terms of the original parameters in each case. be sure to select k so that a(s) and b(s) are monic (i. e., the coefficient of the highest power is 1) in each case and the degree of b(s) is not greater than that of a(s).

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
question
Engineering, 04.07.2019 18:10
True or false (explain) (110)[111] is a slip system in bcc metals . the {111} family in fcc contains 8 planes. resolved shear stress (rss) in single crystals is just related to the applied stress. critical resolved shear stress (crss) in single crystal metals is direct proportional to the number of defects in the structure
Answers: 2
question
Engineering, 04.07.2019 19:10
What are the major differences between injection molding and extrusion?
Answers: 2
question
Engineering, 04.07.2019 19:20
The power source in a certain welding setup generates 3500w that is transferred to the low carbon steel work with a heat transfer factor of 0.85. the melting factor in the operation is 0.45. a continuous fillet weld is to be made with a cross-sectional area of 23 mm2 determine the travel speed at which the welding can be accomplished.
Answers: 3
You know the right answer?
Set up the following characteristic equations in the form suited to evans root-locus method. give l(...
Questions
question
Mathematics, 20.09.2020 05:01
question
English, 20.09.2020 05:01
Questions on the website: 13722367