Engineering, 17.12.2019 22:31 aileenzerr9664

In a particular avionics system a radar altimeter is used to determine the height above the ground level (or agl for short). one of the software components uses the radar altimeter height measurement (radar height) to determine if we are within 50', between 50' and 200', between 200' and 500', or above 500' using the following low-level requirement: if (radar height< 50.0) then below50functiono else if (radar height< 200.0) then between50and200functiono else if (radar height< 500.0) then between200and500functiono else above500functiono endif design the test cases necessary to verify this requirement! what is the problem when you base the choice of test cases on the c-code rather than the requirements?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Ifa component is made of two or more materials with different modulus of elasticity (e), it is called a composite member and we calculate the factor·n". mention the formula for calculating n". also, ifn> 1, explain what will happen to the 1. transformed.gi) ifn 1, what will happen to the material when transformed material when

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

Answer

You know the right answer?

In a particular avionics system a radar altimeter is used to determine the height above the ground l...

Questions