subject
Engineering, 13.12.2019 06:31 21hendlill

1)a rectangular clarifier with a length to width ratio of 3: 1 receives a flow of 850 m3/d. the clarifier’s depth is 4 m and the detention time of the water in the clarifier is2.4 hours. what are the surface overflow rate and horizontal flow through velocity if the flow is distributed uniformly across the cross section of the tank? 2)you are asked to aid in the design of a settling chamber that will be used to remove silica particles from an air stream (temperature = 25degrees c). if the particles have a diameter of 10 x10-6 m and a specific gravity of 2.6, calculate the settling velocity. if the chamber receives a flowrate10 m3/s design a (specify length width and height) chamber that will effectively remove these particles from the airstream.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
The mass flow rate of the fluid remains constant in all steady flow process. a)- true b)- false
Answers: 1
question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:20
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
question
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
You know the right answer?
1)a rectangular clarifier with a length to width ratio of 3: 1 receives a flow of 850 m3/d. the clar...
Questions
question
Biology, 19.12.2020 04:30
question
Mathematics, 19.12.2020 04:30
question
Computers and Technology, 19.12.2020 04:30
question
Mathematics, 19.12.2020 04:30
question
Mathematics, 19.12.2020 04:30
question
English, 19.12.2020 04:30
Questions on the website: 13722362