Engineering, 12.12.2019 04:31 Joshghopper

Home depot. you donít have a pickup truck (nor does your friend), but you do have a roof rack with cross bars on your car. so you will have to secure the plywood to the roof rack in order to get it home. your friend (the one who does not have a pickup truck) suggests that you tie the plywood on sideways (so that the short edge is front to back) and drive at about 13 mph. use standard sea-level conditions = 0: 002369 slugs/ft3 and = 3: 7372 107 slugs (a) estimate the drag on the plywood for the case suggested by your friend. (b) estimate the drag on the plywood if you turn the sheet so that the long edge is front to back. (c) explain why your friend suggested the sideways configuration.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.

Answers: 1

Answer

You know the right answer?

Home depot. you donít have a pickup truck (nor does your friend), but you do have a roof rack with c...

Questions