Engineering, 11.12.2019 21:31 anessia83

Amips-based computer system with 2 gb of main memory that is built on a single circuit board. it is designed with a single control signal between the cpu chip and main memory, i. e. one bit of control that is set to one for read operations and zero for write operations.

a) how many bits wide is the main memory data bus?
b) how many bits wide is the main memory address bus when 4-banks memory interleaved is used?
c) how long does it takes to fetch 8 words from the memory to mips registers? assume that one cycle is required to place the address and one cycle to transfer one word.
d) find the memory bandwidth and compare it to memory bandwidth when no memory interleaved is used.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Agas is compressed from vi 0.3 m, p 1 bar to of v2 0.1 m3, p2--3 bar. pressure and volume are related linearly during the process. for the gas, find the work, in kj.

Answers: 2

Answer

Engineering, 04.07.2019 19:20

To design a steam turbine to produce 12,000 hp power. a engineer comsiders using a steady state stean low st 1160fr and engineer considers using a steady state steam flow at 1160°r and 450 psia to drive this steam turbine. the exhaust of the steam is cooled by the lake (vacuum). heat losing to the surroundings is measured at a rate of 555.55 btu/s. (a) sketch the system with the given conditions. (b) neglecting kinetic and potential energy changes from inlet to exit, determine the volumetric flow rate of the steam at the inlet, (ft'/hr). must clearly show unit conversions at crtical terms.

Answers: 1

Answer

Engineering, 06.07.2019 02:30

A12 mm diameter shaft runs in a plain cylindrical bush 30 mm long that is located in an 18 mm diameter hole in a housing. the shaft-inner bush fit is h8 f and the outer bush-housing fit is h7-p6. make a fully cimensioned sketch of the bush with tolerances. find the maximum and minimum clearance or interference for both fits on the inner and outer diameters of the bush

Answers: 3

Answer

You know the right answer?

Amips-based computer system with 2 gb of main memory that is built on a single circuit board. it is...

Questions