Engineering, 07.12.2019 04:31 Bryson2148

Asignalized intersection approach has three lanes with no exclusive left or right turning lanes. the approach has a 40-second green out of a 75-second cycle. the yellow plus all-red intervals for phase total 4.0 seconds. if the start-up lost time is 2.3s/phase, the clearance lost time is 1.1s/phase, and thesaturation headway is 2.48 s/veh under prevailing conditions, what is the capacity of the intersection approach?

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

You know the right answer?

Asignalized intersection approach has three lanes with no exclusive left or right turning lanes. the...

Questions