Engineering, 07.12.2019 02:31 autumnrose02

Consider an lti system defined by the difference equationy[n] = —2x[n] + 4x[n — 1] — 2x[n — 2].(a) determine the impulse response of this system.(b) determine the frequency response of this system. express your answer in the formh(e j w ) = a(ejw)e—jwnd .where a[ejw) is a real function of w. explicitly specify a(ejw) and the delay nd of this system.(c) sketch a plot of the magnitude |h(ejw)| and a plot of the phase 4h() suppose that the input to the system isx 1[n] = 1 + ej0.5nn —=o< n < co. use the frequency response function to determine the corresponding output y1[n].(e) now suppose that the input to the system isx 2[n] = (1 + ej0.5nn)u[n] —ao< n < co. use the defining difference equation or discrete convolution to determine the corresponding output y2[n] for —ao < n < co. compare y1[n] and y2[n]. they should be equal for certain values of n. over what range of values of n are they equal?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The drive force for diffusion is 7 fick's first law can be used to solve the non-steady state diffusion. a)-true b)-false

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

Answer

You know the right answer?

Consider an lti system defined by the difference equationy[n] = —2x[n] + 4x[n — 1] — 2x[n — 2].(a) d...

Questions