Engineering, 06.12.2019 21:31 cutie777
The extruder head in a fused-deposition modeling setup has a diameter of 1.25 mm (0.05 in.) and produces layers that are 0.25 mm (0.01 in.) thick. if the extruder head and polymer extrudate velocities are both 40 mm/s, estimate the production time for the generation of a 38-mm (1.5-in.) solid cube. assume that there is a 15-second delay after deposition of each layer as the extruder head is moved over a wire brush for cleaning. (4 points)
Answers: 1
Engineering, 03.07.2019 14:10
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
Engineering, 04.07.2019 12:10
On a average work day more than work place firs are reorted
Answers: 1
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
The extruder head in a fused-deposition modeling setup has a diameter of 1.25 mm (0.05 in.) and prod...
Biology, 29.01.2020 21:55
Chemistry, 29.01.2020 21:55
History, 29.01.2020 21:55
Mathematics, 29.01.2020 21:55
Geography, 29.01.2020 21:55
Chemistry, 29.01.2020 21:55
Mathematics, 29.01.2020 21:55
Mathematics, 29.01.2020 21:55
Mathematics, 29.01.2020 21:55
Mathematics, 29.01.2020 21:55
Chemistry, 29.01.2020 21:55
Mathematics, 29.01.2020 21:55
History, 29.01.2020 21:55