subject
Engineering, 06.12.2019 04:31 michealbanks3

Professor gekko has always dreamed of inline skating across north dakota. he plans to cross the state on highway u. s. 2, which runs from grand forks, on the eastern border with minnesota, to williston, near the western border with montana. 428 chapter 16 greedy algorithms the professor can carry two liters of water, and he can skate m miles before running out of water. (because north dakota is relatively flat, the professor does not have to worry about drinking water at a greater rate on uphill sections than on flat or downhill sections.) the professor will start in grand forks with two full liters of water. his official north dakota state map shows all the places along u. s. 2 at which he can refill his water and the distances between these locations. the professor’s goal is to minimize the number of water stops along his route across the state. give an efficient method by which he can determine which water stops he should make. prove that your strategy yields an optimal solution, and give its running time.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0
Answers: 3
question
Engineering, 04.07.2019 19:10
When subject to a steady load (within elastic range) over a long period of time, what is the major difference in material behavoir between steel and plastic?
Answers: 2
question
Engineering, 06.07.2019 02:30
A12 mm diameter shaft runs in a plain cylindrical bush 30 mm long that is located in an 18 mm diameter hole in a housing. the shaft-inner bush fit is h8 f and the outer bush-housing fit is h7-p6. make a fully cimensioned sketch of the bush with tolerances. find the maximum and minimum clearance or interference for both fits on the inner and outer diameters of the bush
Answers: 3
question
Engineering, 06.07.2019 03:20
What is the maximum height from which a mass of 30 kg can fall on to a flange on the lower end of a vertical rod of length 1.0 m and diameter 20 mm, the upper end being rigidly fixed, if the stress in the rod is not to exceed 80 mpa? the tensile modulus of the rod is 200 gpa.
Answers: 3
You know the right answer?
Professor gekko has always dreamed of inline skating across north dakota. he plans to cross the stat...
Questions
question
Chemistry, 25.11.2020 06:00
question
Mathematics, 25.11.2020 06:00
question
Mathematics, 25.11.2020 06:00
question
Mathematics, 25.11.2020 06:00
question
Mathematics, 25.11.2020 06:00
Questions on the website: 13722363