Engineering, 06.12.2019 00:31 niescarlosj

Grade is a measure of quality and it captures concentration levels (i. e., how pure a certain fraction is). if grade captures quality, then recovery is a measure of quantity: it describes how much of a certain material in the input stream is made available for reprocessing. a recovery of r% means that (100 - r)% of the material going into the process is lost, ending up either in mine tailings or as a contaminant in one or more fractions. by weight, copper wire contains about 70% copper and 30% pvc. suppose we process 1 ton of wire per hour into a copper fraction of 0.74 ton/hour, of which 0.69 is copper and 0.05 is pvc. what is the weight and composition of the tailing? and what are the grade and recovery of the copper?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m

Answers: 2

Answer

You know the right answer?

Grade is a measure of quality and it captures concentration levels (i. e., how pure a certain fracti...

Questions