Engineering, 05.12.2019 23:31 olejlund8073

Develop a failure envelope for the below data for a plain weave carbon fiber tow according to the tsai-wu orthotropic failure theory. assume that plane stress conditions exist. [note: you must accurately plot enough points to determine the shape of the envelopes! accurate plotting requires either software or meticulous paper graphing. you must as always indicate your procedure.) below in mpa x = axial strength = sl y = transverse strength = st s = shear strength tension =t="" compression = c = "." 2.31e+09 7.48e+08 4.81e+07 1.46e+08 4.74e+07 use f12 = 4.55e-18 pa" (i. e. consistent with using base units of pa)

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 19:10

10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

For a process taking place in a closed system containing gas, the volume and pressure relationship is pvi-constant. -1.5 bar, the process starts with initial conditions, pi = =0.03 m3 and ends with final volume, v2-0.05 m3 determine the work done by the gas.

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Heat transfer by is the fastest mode of heat transfer that requires no intervening medium. a)-conduction b)-convection c)-radiation d)-conduction and convection

Answers: 1

Answer

You know the right answer?

Develop a failure envelope for the below data for a plain weave carbon fiber tow according to the ts...

Questions