Engineering, 05.12.2019 20:31 mem8163
1. define common mode and difference mode gain, and cmrr. how does one determine these quantities via in-circuit measurements? 2. review the use and setup of an instrumentation amplifier, op amp offset voltage nulling, a first order passive hp filter and a first order active lp filter. explain why an instrumentation amplifier is designed with two stages (i. e., what does each stage do? ) and also the purpose of offset nulling in an op amp. 3. design circuit blocks as follows using common resistors and capacitors (i. e., 10 pf caps, 10 k ohm resistors, etc.): passive hp filter: break frequency of about .5 hz (~3 radians/sec) active lp filter: break frequency of about 100 hz (~630 radians/sec) instrumentation amplifier with input stage amplification of > 50 and difference stage amplification of greater than > 20.
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
Engineering, 04.07.2019 18:20
Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options
Answers: 2
Engineering, 04.07.2019 18:20
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
Engineering, 04.07.2019 19:10
What is the major difference between thermoplastics and thermosetting plastics from the polymerization structure point of view?
Answers: 2
You know the right answer?
1. define common mode and difference mode gain, and cmrr. how does one determine these quantities vi...
Questions
