Engineering, 05.12.2019 05:31 rwallacejr803

A2.4 liter, four stroke cycle engine is equipped with multipoint port fuel injection, having one injector per cylinder. the injectors are constant flow devices, so the fuel flow rate into the engine is controlled by the injection pulse duration. maximum power is obtained at wot when injection duration is continuous. at this condition, engine speed is at 5800 rpm with stoichiometric gasoline and an inlet pressure of 101 kpa. at idle condition, the engine speed is 600 rpm with stoichiometric gasoline and an inlet pressure of 30 kpa. volumetric efficiency can be considered 95% at wot. calculate:

a) fuel flow rate through an injector

b) injection pulse duration in seconds at idle conditions

c) injection pulse duration in degrees of engine rotation at idle conditions

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 08:10

Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]

Answers: 3

Answer

You know the right answer?

A2.4 liter, four stroke cycle engine is equipped with multipoint port fuel injection, having one inj...

Questions