Engineering, 03.12.2019 18:31 jetskiinbunny31
Aplastic part with a length of 100 mm and 10 mm is made of acetal. if it is subjected to a stress of 15 mpa for 3000 hr, what would be the length and diameter of the part at this time?
assume the yield strength and poissonâs ratio are 60 mpa and 0.43 respectively.
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 14:10
Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Engineering, 04.07.2019 18:20
Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?
Answers: 3
Engineering, 04.07.2019 18:20
Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency
Answers: 1
You know the right answer?
Aplastic part with a length of 100 mm and 10 mm is made of acetal. if it is subjected to a stress of...
Questions
Geography, 10.03.2020 18:30
Mathematics, 10.03.2020 18:30
Mathematics, 10.03.2020 18:30
