Engineering, 30.11.2019 01:31 saskiat1155

Arigid pavement is designed with an 11-inch slab thickness, 90% reliability, = 4 million lb/in2 , modulus of rupture of 600 lb/in2 , modulus of subgrade reaction of 150 lb/in3 , a 2.8 load transfer coefficient, initial psi = 4.8, tsi = 2.5, overall standard deviation of 0.35, and a drainage coefficient of 0.8. the pavement has a 20-year design life. the pavement has three lanes and is conservatively designed for trucks that have one 20,000-lb single axle, one 26,000-lb tandem axle, and one 34,000-lb triple axle. what is the estimated directional daily truck traffic? [15 points]

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)

Answers: 1

Answer

Engineering, 04.07.2019 19:10

The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]

Answers: 3

Answer

Engineering, 04.07.2019 19:20

The power source in a certain welding setup generates 3500w that is transferred to the low carbon steel work with a heat transfer factor of 0.85. the melting factor in the operation is 0.45. a continuous fillet weld is to be made with a cross-sectional area of 23 mm2 determine the travel speed at which the welding can be accomplished.

Answers: 3

Answer

You know the right answer?

Arigid pavement is designed with an 11-inch slab thickness, 90% reliability, = 4 million lb/in2 , m...

Questions