Engineering, 29.11.2019 04:31 amunnik04

Ahorizontal water jet of constant velocity v impinges normally on a vertical flat plate and splashes off the sides in the vertical plane. the plate is moving toward the oncoming water jet with a velocity of 1/2v. if a force f is required to maintain the plate stationary, how much force is required to move the plate toward the water jet?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

A)-in the process of engineering design, explain the contribution of material selection. b)- explain the procedure of synthesis as is employed in engineering design. c)- is there any relationship between ergonomics and engineering design? explain. d)- safety consideration in engineering design includes human, product and the enviroment . explain how safety will be incorporated into the design?

Answers: 3

Answer

Engineering, 04.07.2019 19:20

Acircular pipe of 30mm outside diameter is placed in an airstream at 30 c and latm pressure. the air moves in cross flow over the pipe at 20 m/s, while the outer surface of the pipe is maintained at 110 c. what is the drag force exerted on the pipe per unit length? what is the rate of heat transfer from the pipe per unit length?

Answers: 1

Answer

You know the right answer?

Ahorizontal water jet of constant velocity v impinges normally on a vertical flat plate and splashes...

Questions