subject
Engineering, 28.11.2019 06:31 papasully1

Experimental measurements of the convection heat transfer coefficient for a square bar in cross flow yielded the following values. the two experimental values were both found for air with a constant prandlt number. h_1 = 50w/m^2 middot k when v_1 = 20m/s h_2 = 40w/m^2 middot k when v_2 = 15 m/s assume that the functional form of the nusselt number is nu = cre^m pr^n where c, m, and n are all constants. do not use the values from chapter 7, they would like you derive a relationship. a) use the definition of the nusselt number and the definition of the reynolds number to determine what parameters are constant for the two experiments, and what parameters will change. substitute these definitions into the nusselt correlation given (you probably want to look at a ratio of nu_1/nu_2 and develop a simplified form of the correlation. solve for the numerical value of constant m based on the experimental data given. b) use your simplified relationship to determine the convection heat transfer for a similar bar with l = 1 when v = 15m/s. c) use your simplified relationship to determine the convection heat transfer for a similar bar with l = 1 when v = 30m/s. d) would your results change if the length of the bar was used for l rather than the diagonal as shown?

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?
Answers: 3
question
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
question
Engineering, 04.07.2019 18:10
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
question
Engineering, 04.07.2019 18:10
Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.
Answers: 3
You know the right answer?
Experimental measurements of the convection heat transfer coefficient for a square bar in cross flow...
Questions
question
Mathematics, 28.01.2021 23:30
question
Mathematics, 28.01.2021 23:30
question
Mathematics, 28.01.2021 23:30
question
Mathematics, 28.01.2021 23:30
Questions on the website: 13722367