subject
Engineering, 28.11.2019 03:31 angelolucero146

The following situations represent excerpts from the responses to audit inquiries of external legal counsel of xyz co. during the annual audit of year 1 ("legal response"). for each excerpt, select the most appropriate financial statement effect and audit response. each excerpt is independent. responses may be used once, more than once, or not at all from the table below: a. the client’s year end is december 31, year 1. b. the anticipated audit report date is february 15, year 2. c. all amounts are material to the financial statements. financial statement effect audit response 1. no impact on financial statement amounts or notes. 7. legal response is appropriately dated. 2. disclosure in notes relating to nature of litigation, but no amount disclosed. 8. update legal response. 3. disclosure in notes relating to nature of litigation, including loss amount. 9. update audit report date. 4. potential litigation settlement accrued in financial statements. 5. potential litigation settlement not accrued in financial statements, amount disclosed in notes. 6. verify amount due attorney is recorded in financial statement amounts.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk
Answers: 1
question
Engineering, 04.07.2019 18:10
Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.
Answers: 1
question
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
question
Engineering, 04.07.2019 19:20
The power source in a certain welding setup generates 3500w that is transferred to the low carbon steel work with a heat transfer factor of 0.85. the melting factor in the operation is 0.45. a continuous fillet weld is to be made with a cross-sectional area of 23 mm2 determine the travel speed at which the welding can be accomplished.
Answers: 3
You know the right answer?
The following situations represent excerpts from the responses to audit inquiries of external legal...
Questions
question
Chemistry, 22.02.2021 21:40
question
Mathematics, 22.02.2021 21:40
question
Computers and Technology, 22.02.2021 21:40
question
Mathematics, 22.02.2021 21:40
question
Mathematics, 22.02.2021 21:40
Questions on the website: 13722367