Engineering, 28.11.2019 03:31 bluevibe

Aplant has two identical standby generator units for emergency use. in the area of the generators, the normal noise level registers 81 dba on the sound-level meter with the generators turned off. when one generator switches on, the slm needle jumps to 83.6 dba. (a) perform calculations to determine what the dba reading will be when the second generator also turns on (so that both generators are on). (b) if both generators are on for a full 8-hour shift, will osha's pel be exceeded? will the al be exceeded? explain. (c) if one generator is on for half the shift and both are on for the other half, will the pel be exceeded? will the al be exceeded? explain. (d) in the absence of any plant background noise, what would be the sound level contributed by a single generator? by both generators? show calculations to explain.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.

Answers: 3

Answer

Engineering, 03.07.2019 14:10

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.

Answers: 1

Answer

You know the right answer?

Aplant has two identical standby generator units for emergency use. in the area of the generators, t...

Questions