subject
Engineering, 27.11.2019 00:31 maxy7347go

Acombined gas-steam power cycle uses a simple gas turbine for the topping cycle and simple rankine cycle for the bottoming cycle. for the topping cycle, air enters to the compressor at the temperature of 293 k and experiences a compression ratio of 8 with efficiency of 0.85. the temperature of air after the combustion reaches to a maximum of 1100degree c. the air experiences an expansion ratio of 8 with efficiency of 0.9 in the turbine. the air at the outlet of turbine flows through a heat exchanger to transport thermal energy to the bottoming cycle and leaves at a temperature corresponding to water saturation temperature at 6 mpa. for the bottoming cycle, water enters in the saturated state at pressure of 20 kpa to an ideal pump. the vapor at the inlet of turbine is at 320degree c and 6 mpa. the vapor goes through a turbine with isentropic efficiency of 0.9. the properties of air at room temperature are c_p = 1.005 kj/kg-k and k= 1.4 show the t-s diagram of this combined cycle. determine the net work of the topping and bottoming cycles. determine the mass flow rate of ah' for a power output of 100 mw.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 15:10
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
question
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
question
Engineering, 04.07.2019 18:20
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
question
Engineering, 04.07.2019 19:10
The maximum shear stress and maximum flexural stress occur at the same location along a beam subjected to a non-uniform bending load. a)-trune b)- false
Answers: 2
You know the right answer?
Acombined gas-steam power cycle uses a simple gas turbine for the topping cycle and simple rankine c...
Questions
question
Biology, 11.02.2020 04:01
Questions on the website: 13722361