Engineering, 26.11.2019 01:31 maru91

Afuel oil is burned with air in a boiler furnace. the combustion produces 813 kw of thermal energy of which 65z5 is transferred as heat to the boiler tubes that pass through the furnace. the combustion products pass from the furnace to a stack at 650 deg c. liquid water enters the boiler tubes at 20 deg c and leaves the tubes as saturated steam at 20 bar absolute. (a) calculate the rate (kg/sec) at which steam is produced. (b) estimate the volumetric flow rate of steam produced (m^3/sec) using the steam tables. (c) repeat part (b) using the ideal gas law. which result would you trust more, and why? (d) what happened to the 35% of the combustion energy that did not get transferred to the boiler tubes?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa

Answers: 1

Answer

You know the right answer?

Afuel oil is burned with air in a boiler furnace. the combustion produces 813 kw of thermal energy o...

Questions