subject
Engineering, 20.11.2019 20:31 jada741

Schematic below shows a discrete-circuit amplifier. the input signal v. is sig coupled to the gate through a very large capacitor (shown as infinite). the transistor source is connected to ground at signal frequencies via a very large capacitor (shown as infinite). the output voltage signal that develops at the drain is coupled to a load resistance via a very large capacitor (shown as infinite) the transistor has voltages and currents gs vds ,id) (v b. find g, and r if va 100 v c. draw a complete small-signal equivalent circuit for the amplifier, assuming all capacitors behave as short circuits at signal frequencies d. find rin, rout, voltage gain vo vgs, and overall voltage gain vo sig 15 v 100 mn 7.5 km rsig 100 km 10 km 5 mn 3 km

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
question
Engineering, 04.07.2019 18:20
The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?
Answers: 3
question
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
question
Engineering, 04.07.2019 19:20
The power source in a certain welding setup generates 3500w that is transferred to the low carbon steel work with a heat transfer factor of 0.85. the melting factor in the operation is 0.45. a continuous fillet weld is to be made with a cross-sectional area of 23 mm2 determine the travel speed at which the welding can be accomplished.
Answers: 3
You know the right answer?
Schematic below shows a discrete-circuit amplifier. the input signal v. is sig coupled to the gate t...
Questions
question
English, 19.02.2021 06:10
question
Chemistry, 19.02.2021 06:10
question
Mathematics, 19.02.2021 06:10
question
Mathematics, 19.02.2021 06:10
question
Mathematics, 19.02.2021 06:10
question
Mathematics, 19.02.2021 06:10
question
Mathematics, 19.02.2021 06:10
question
Chemistry, 19.02.2021 06:10
Questions on the website: 13722363