Engineering, 19.11.2019 23:31 solphiafischer

Two 2.30 cm × 2.30 cm plates that form a parallel-plate capacitor are charged to ± 0.708 nc . part a what is the electric field strength inside the capacitor if the spacing between the plates is 1.00 mm ? express your answer with the appropriate units. e e = nothing nothing submitrequest answer part b what is potential difference across the capacitor if the spacing between the plates is 1.00 mm ? express your answer with the appropriate units. v v = nothing nothing submitrequest answer part c what is the electric field strength inside the capacitor if the spacing between the plates is 2.00 mm ? express your answer with the appropriate units. e e = nothing nothing submitrequest answer part d what is the potential difference across the capacitor if the spacing between the plates is 2.00 mm ? express your answer with the appropriate units. v v = nothing nothing submitrequest answer provide feedback next

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Plan an experiment to measure the surface tension of a liquid similar to water. if necessary, review the ncfmf video surface tension for ideas. which method would be most suitable for use in an undergraduate laboratory? what experimental precision could be expected?

Answers: 2

Answer

You know the right answer?

Two 2.30 cm × 2.30 cm plates that form a parallel-plate capacitor are charged to ± 0.708 nc . part a...

Questions