subject
Engineering, 19.11.2019 07:31 jstringe424

If an organization must evaluate the following three information assets for risk management, which vulnerability should be evaluated first for additional safety controls? which should be evaluated last? ·switch l47 connects a network to the internet. it has two vulnerabilities: it is susceptible to hardware failure at a likelihood of 0.2, and it is subject to an snmp buffer overflow attack at a likelihood of 0.1. this switch has an impact rating of 90 and has no current controls in place. you are 75% certain of the assumptions and data. ·server websrv6 hosts a company web site and performs e-commerce transactions. it has a web server version that can be attacked by sending it invalid unicode values. the likelihood of that attack is estimated at 0.1. the server has been assigned an impact value of 100, and a control has been implanted that reduces the impact of vulnerability by 75%. you are 80% certain of the assumptions and data. ·operators use an mgmt45 control console to monitor operations in the server room. it has no passwords and is susceptible to unlogged misuse by the operators. estimates show the likelihood of the misuse is 0.1. there are no controls in place on this asset; it has an impact rating of 5. you are 90% certain of the assumptions and data.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
question
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
question
Engineering, 04.07.2019 19:10
Plan an experiment to measure the surface tension of a liquid similar to water. if necessary, review the ncfmf video surface tension for ideas. which method would be most suitable for use in an undergraduate laboratory? what experimental precision could be expected?
Answers: 2
question
Engineering, 05.07.2019 23:20
Which one of the following faults cause the coffee in a brewer to keep boiling after the brewing cycle is finished? a. an open circuit in the heating element b. a short circuit at the terminals c. welded contacts on the thermostat d. a leak around the gasket
Answers: 3
You know the right answer?
If an organization must evaluate the following three information assets for risk management, which v...
Questions
question
Mathematics, 02.02.2020 21:01
question
English, 02.02.2020 21:01
question
Mathematics, 02.02.2020 21:01
question
Mathematics, 02.02.2020 21:01
Questions on the website: 13722363