Engineering, 17.11.2019 03:31 haleymoodie1998

Asimple supported beam at x0 = 0 and xn = l with a uniform load w and the

vertical deflection v(x) is described by the boundary value problem

d

2

v

dx2

=

x−l

3ei

wx, v(0) = 5, v(l) = 100

where l is the length of the beam, e represents the young’s modulus of the material from which

the beam is fabricated and i is the second moment of area of the beam’s cross–section. suppose

l = 15 m, e = 210 kn/m

2

, i = 370.5 m2

and w = 9.8 kn/m. use the shooting method to

approximate the vertical deflection, v(x) with the step size, h = 3, the first guess, z0 = 10 and

the second guess, z0 = 5.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Ifa component is made of two or more materials with different modulus of elasticity (e), it is called a composite member and we calculate the factor·n". mention the formula for calculating n". also, ifn> 1, explain what will happen to the 1. transformed.gi) ifn 1, what will happen to the material when transformed material when

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

Answer

Engineering, 04.07.2019 19:20

Air enters a horizontal, constant-diameter heating duct operating at steady state at 290 k, 1 bar, with a volumetric flow rate of 0.25 m°/s, and exits at 325 k, 0.95 bar. the flow area is 0.04 m2. assuming the ideal gas model with k = 1.4 for the air, determine (a) the velocity at the inlet and exit, each in m/s, and (c) the rate of heat transfer, in kw flow rate, in kg/s, (b) the mass kg 0.3

Answers: 2

Answer

Engineering, 06.07.2019 02:30

In a unit cell of fcc structure, indicate the position of one of the tetrahedral interstitial sites by plotting the corresponding tetrahedron. do the same for one of the octahedral interstitial sites (in a separate fcc unit cell). mark the positions of all the tetrahedral and octahedral interstitial sites in the unit cells. how many equivalent tetrahedral sites and how many equivalent octahedral sites are contained in a fcc unit cell, respectively. what is the coordination number for a tetrahedral site and what is the coordination number for an octahedral site?

Answers: 2

Answer

You know the right answer?

Asimple supported beam at x0 = 0 and xn = l with a uniform load w and the

vertical defle...

Questions