Engineering, 15.11.2019 06:31 hartzpeyton136

8.6 wp water is the working fluid in an ideal rankine cycle. steam enters the turbine at 1400 lbf/in.2 and 1000°f. the condenser pressure is 2 lbf/in.2 the net power output of the cycle is 1 × 109 btu/h. cooling water experiences a temperature increase from 60°f to 76°f, with negligible pressure drop, as it passes through the condenser.

determine for the cycle

a. the mass flow rate of steam, in lb/h.
b. the rate of heat transfer, in btu/h, to the working fluid passing through the steam generator.
c. the thermal efficiency.
d. the mass flow rate of cooling water, in lb/h.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

Answer

You know the right answer?

8.6 wp water is the working fluid in an ideal rankine cycle. steam enters the turbine at 1400 lbf/in...

Questions