subject
Engineering, 14.11.2019 20:31 jaimephelps17

Two current sheets are fixed in free space in the x = 0 plane and the x = lambda/4 plane with surface current densities given by j_s (t) = j_1 cos(omega t + phi) z cap a/m and j_8(t) = j_2 cos(omega t)y cap a/m, respectively, where j_1, j_2, and phi are real numbers. tem waves will propagate away from each sheet and superpose with each other to create a wavefield whose polarization depends on the phase phi of the surface current at x = 0 and on the ratio j_2/j_1. assuming that j_2/j_1 = 1, determine the value(s) for phi required for the superposed tem waves propagating in the region x > lambda/4 to have the following polarizations. justify your choice of phi case by determining the electric field phasor produced in the region x > lambda/4 with your choice of phi. a) right handed circular polarization b) left handed circular polarization c) linear polarization

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 14:10
Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.
Answers: 3
question
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
You know the right answer?
Two current sheets are fixed in free space in the x = 0 plane and the x = lambda/4 plane with surfac...
Questions
question
Mathematics, 20.02.2020 03:57
question
Mathematics, 20.02.2020 03:57
question
Mathematics, 20.02.2020 03:57
Questions on the website: 13722363