Engineering, 13.11.2019 21:31 oddoneshenchman

1. the distortion of an audio amplifier is often specified in terms of "total harmonic distortion", or thd. to measure thd, the amplifier is driven by a pure sinusoidal input signal. if the amplifier is not linear, the amplifier output will include power at the harmonics of the test frequency. the thd is defined the ratio of the rms value of all distortion terms (2"nd harmonic and above) at the amplifier output to the rms value of the fundamental (thd is often specified as a percentage.) note: parseval's theorem implies that the power in the harmonics may be added together to get the total distor- tion power. (the rms voltages cannot be directly added to get a meaningful result.) assume that a system is being tested using a 300 hz test signal. a spectrum analyzer is used to measure the harmonic content of the output signal, giving the following measurements: frequency (hz)amplitude (dbv) 300 2.8 600 -19.2 900 -15.1 1200 -17.3 1500 -22.0 assume that harmonics higher than the 54h harmonic have negligible power. calculate the thd of the amplifier.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

Answer

Engineering, 04.07.2019 16:10

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Ifa component is made of two or more materials with different modulus of elasticity (e), it is called a composite member and we calculate the factor·n". mention the formula for calculating n". also, ifn> 1, explain what will happen to the 1. transformed.gi) ifn 1, what will happen to the material when transformed material when

Answers: 1

Answer

You know the right answer?

1. the distortion of an audio amplifier is often specified in terms of "total harmonic distortion",...

Questions