Engineering, 13.11.2019 20:31 yvngtazz

An inexpensive food and beverage container is fabricated from 25-mni-thick polystyrene (k = 0.023 w/m k) and has interior dimensions of 0.8 m times 0.6 m times 0.6 m. under conditions for which an inner surface temperature of approximately 2 degree c is maintained by an ice-water mixture and an outer surface temperature of 20 degree c is maintained by the ambient, what is the heat flux through the container wall? assuming negligible heat gain through the 0.8 m times 0.6 m base of the cooler, what is the total heal load for the prescribed conditions?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Ifa component is made of two or more materials with different modulus of elasticity (e), it is called a composite member and we calculate the factor·n". mention the formula for calculating n". also, ifn> 1, explain what will happen to the 1. transformed.gi) ifn 1, what will happen to the material when transformed material when

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

Answer

Engineering, 04.07.2019 19:10

The short distance from the objective lens to the object causes problems at high magnification. which of the following is the most serious? a. cleaning the object surface b. positioning the object c. reflection from the object surface. d. illumination of the object

Answers: 1

Answer

You know the right answer?

An inexpensive food and beverage container is fabricated from 25-mni-thick polystyrene (k = 0.023 w/...

Questions