The power supplies in 1206 mudd feature an internal protection mechanism that limits the output current to 1 ampere. ideally, the protection circuit engages instantaneously when an over-current fault is detected, then disengages instantaneously once the fault condition is removed. while in the current limited state, the supply acts like an ideal current source. now suppose you set a supply to 5v then connect a fully discharged ideal 500mf (huge! ) capacitor to the the output. the supply will immediately go into current-limit. (a) why?

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

The higher the astm grain-size number, the coarser the grain is. a)-true b)-false

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.