Engineering, 12.11.2019 06:31 sadsociety41

Flue gas is cooled from 1373.15 k to 400 k and the heat is used to generate saturated steam at 100 °c in a boiler. the flue gas heat capacity is given by: cp /r = 3.83 + 0.000551t. water enters the boiler at 100 °c and is vaporized at this temperature, 100 °c. (its latent heat of vaporization is 2256.9 kj/kg).

a. with reference to the surrounding temperature of 15 °c, what is the lost work in units of kj/mol flue gas?

b. with reference to the surrounding temperature of 15 °c, what is the maximum work in kj/mol flue gas that can be accomplished by the saturated steam at 100 °c if it condenses only and does not subcool?

c. what is the maximum work theoretically obtainable from the flue gas itself as it cools from 1373.15 k to 4000 k? (the surrounding temperature at 15 °c)

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

Answer

You know the right answer?

Flue gas is cooled from 1373.15 k to 400 k and the heat is used to generate saturated steam at 100 °...

Questions