Engineering, 09.11.2019 07:31 helo55

Revise the following sentences to convert the negative constructions to positive constructions. a. management accused williams of filing trip reports that were not accurate. b. we must make sure that all our representatives do not act unprofessionally to potential clients. 23. general readers might find the following sentences awkward or difficult to understand. refer to the advice on page 235, and rewrite the following sentences to eliminate the long noun strings. a. the research team discovered a glycerin-initiated, alkylene-oxide-based, long-chain polyether. b. we are considering purchasing a digital-imaging capable, diffusion-pump equipped, tungsten-gun sem.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero

Answers: 2

Answer

You know the right answer?

Revise the following sentences to convert the negative constructions to positive constructions. a. m...

Questions