Engineering, 08.11.2019 01:31 Bbmonstr8279
Consider the extrusion of a cylindrical billet. assume the starting billet to have a length of 0.3 m and a diameter of 15 cm. this is extruded into a cylindrical product that is 3 cm in diameter and 7.5 m long (a reduction ratio of 25). neglecting the areas on the two ends, compute the ratio between the product surface area (wrap around cylinder) and the surface area of the starting billet. (2 points)
Answers: 1
Another question on Engineering
Engineering, 03.07.2019 14:10
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk
Answers: 1
You know the right answer?
Consider the extrusion of a cylindrical billet. assume the starting billet to have a length of 0.3 m...
Questions
Physics, 15.12.2021 20:00
English, 15.12.2021 20:00
Social Studies, 15.12.2021 20:00
History, 15.12.2021 20:00
Physics, 15.12.2021 20:00
Arts, 15.12.2021 20:00
Mathematics, 15.12.2021 20:00
