subject
Engineering, 08.11.2019 00:31 sighgabbie

An aqueous salt solution (salt + water) is fed to a two-unit evaporation-crystallization process. the fresh feed to the overall process contains 12.0 wt% salt. in the evaporator, pure water is removed at 225 kg/s. this is 55.0% of the water entering the evaporator. the concentrated salt stream leaves the evaporator and flows into the crystallizer where temperature is reduced. two streams exit the crystallizer. one is an aqueous salt stream containing 25.0 wt% salt; this stream is recycled and joins the fresh feed stream entering the evaporator. the other stream leaving the crystallizer is the product stream and contains solid salt crystals and a small amount of 25.0 wt% salt solution (at a ratio of 10.0 kg salt crystals/kg solution).

(a) draw a flowchart and label all streams. incorporate all of the information given above. use s to denote salt and w to denote water.

(b) do a degree of freedom analysis on the process and show you have enough information to solve for all unknowns.

(c) calculate the production rate of solid salt crystals, the flowrate of the fresh feed stream, and the recycle ratio: (kg/s recycled)/(kg/s fresh feed)

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
question
Engineering, 04.07.2019 18:10
The higher the astm grain-size number, the coarser the grain is. a)-true b)-false
Answers: 3
question
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
question
Engineering, 04.07.2019 18:20
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
You know the right answer?
An aqueous salt solution (salt + water) is fed to a two-unit evaporation-crystallization process. th...
Questions
question
Mathematics, 24.02.2021 07:20
question
Mathematics, 24.02.2021 07:20
question
Mathematics, 24.02.2021 07:20
question
Social Studies, 24.02.2021 07:20
question
Computers and Technology, 24.02.2021 07:20
question
Computers and Technology, 24.02.2021 07:20
Questions on the website: 13722360