Engineering, 07.11.2019 05:31 walkereddie580

Asheet metal manufacturer is making 10-gauge sheet metal, which is supposed to be 3.416 mm thick. one of the pieces of manufacturing equipment was suspected of malfunctioning, so the manufacturer tested a random sample of 100 pieces of steel to make sure the average steel thickness is 3.416 mm. which of the following is a statement of the null hypothesis? the equipment is not working properly. the average average steel thickness is not 3.416 mm. the equipment is working properly. the average average steel thickness is 3.416 mm. the equipment is making the sheet metal too thick. the average average steel thickness is greater than 3.416 mm.

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

Answer

Engineering, 04.07.2019 16:10

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency

Answers: 1

Answer

You know the right answer?

Asheet metal manufacturer is making 10-gauge sheet metal, which is supposed to be 3.416 mm thick. on...

Questions