subject
Engineering, 07.11.2019 00:31 jmonee

Safety application

a 20,000-liter storage tank was taken out of service to repair and reattach a feed line damaged in a collision with a tanker. the tank was drained and then opened several days later for a welder to enter and perform the required work. no one realized, however, that 5 liters of liquid nonane (c9h20) remained in a collection sump at the bottom of the tank after the draining had been completed.

(a)

nonane has a lower explosive limit of 0.80 mole% and an upper explosive limit of 2.9 mole%8 (i. e., nonane-air mixtures at 1 atm can explode when exposed to a spark or flame if the nonane mole fraction is between the two given values). assume any liquid nonane that evaporates spreads uniformly throughout the tank. is it possible for the average gas-phase composition in the tank to be within the explosive limits at any time? even when the average composition falls outside those limits, why is an explosion still a possibility?

(hint: think about that assumption.)

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
question
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
question
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
question
Engineering, 04.07.2019 18:10
Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines
Answers: 1
You know the right answer?
Safety application

a 20,000-liter storage tank was taken out of service to repair and re...
Questions
question
Social Studies, 19.06.2020 05:57
question
Mathematics, 19.06.2020 05:57
Questions on the website: 13722359