subject
Engineering, 06.11.2019 20:31 igtguith

Adisplacement transducer has the following specifications:

linearity error: ±0.25% reading

drift: ±0.05% /℃ reading

sensitivity error: ±0.25% reading

excitation : 10-25 vdc output: 0-5 vdc

range: 0-5 cm

the transducer output is to be indicated on a voltmeter having a stated accuracy of ±0.1% reading with a resolution of 10 μv. the system is to be used at room temperature , which can vary by ±10℃. estimate an uncertainty in a normal displacement of 2 cm at design stage. assume 95% confidence.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
question
Engineering, 04.07.2019 18:20
Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t
Answers: 3
question
Engineering, 04.07.2019 18:20
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
question
Engineering, 04.07.2019 18:20
Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency
Answers: 1
You know the right answer?
Adisplacement transducer has the following specifications:

linearity error: ±0.25% rea...
Questions
question
Mathematics, 17.12.2020 23:00
Questions on the website: 13722363