Engineering, 06.11.2019 06:31 ijohnh14
In r, write a function that inputs a numeric vector and implements the sorting algorithm described below. for every index position of a vector starting with position 1 until the second to last index position:
• find the least valued element to the right of the index position. • if the least valued element to the right of the index position you are working on is less than the value in the index position, switch the positions of the least valued element to the right of the index position and the element in the index position.
the body of the function cannot use any function related toetc.
the output of the function should be the sorted values from the input vector.
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
Engineering, 04.07.2019 18:20
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
Engineering, 04.07.2019 18:20
For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.
Answers: 1
Engineering, 04.07.2019 19:10
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
You know the right answer?
In r, write a function that inputs a numeric vector and implements the sorting algorithm described b...
Questions
Social Studies, 28.01.2020 18:49
Computers and Technology, 28.01.2020 18:49
Computers and Technology, 28.01.2020 18:49
Arts, 28.01.2020 18:49
