Engineering, 05.11.2019 06:31 Chrissyx5215
Problem 9.032 si air enters the compressor of an ideal cold air-standard brayton cycle at 100 kpa, 300 k, with a mass flow rate of 6 kg/s. the compressor pressure ratio is 7, and the turbine inlet temperature is 1000 k. for k = 1.4 and cp = 1.005 kj/kg, calculate: (a) the percent thermal efficiency of the cycle. (b) the back work ratio. (c) the net power developed, in kw.
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Engineering, 06.07.2019 03:10
Steel balls 12 mm in diameter are annealed by heating to 1150 k and then slowly cooled to 400 k in an air att 325 k and h -20 w/m2 k. assume the properties of the steel to be k- 40 w/m k,p 7800 kg/m3, and cp 600 j/kg k. a. determine whether lumped system method can be used to analyze this problem and if so why" b. determine the time required for the cooling process. c. determine the total amount of heat lost from each ball to the ambient air
Answers: 1
Engineering, 06.07.2019 03:10
Consider a 1.2 meter high and 2 meter wide glass window whose thickness is 6 mm and thermal conductivity is 0.78 w/m °c. the room temperature is maintained at 24 °c, while the outdoor temperature is -5 °c. the convective heat transfer coefficients on the inner and outer surfaces of the window are 10 w/m2 °c and 25 w/m2 °c respectively. (a) draw the thermal resistance network, etermine the steady rate of heat transfer t e glass window (c) determine the temperature of the inner surface of the window
Answers: 3
Engineering, 06.07.2019 03:30
Abrayton cycle operates with a regenerator on the air-standard with properties evaluated at 400 k. the tem- perature of the air entering the compressor is 350k while the temperature of the air exiting the compressor is 600 k. the temperature of the air entering the turbine is 1600 k. the overall cycle produced 600 kj/kg of net work out. assuming a regenerator effectiveness of 0.8, what is the temperature of the air before heat addition (combustion)? draw this process on a t - s diagram
Answers: 3
Problem 9.032 si air enters the compressor of an ideal cold air-standard brayton cycle at 100 kpa, 3...
Mathematics, 31.03.2020 06:04
English, 31.03.2020 06:04
English, 31.03.2020 06:04
Mathematics, 31.03.2020 06:04
History, 31.03.2020 06:04
Social Studies, 31.03.2020 06:04
Biology, 31.03.2020 06:04
Biology, 31.03.2020 06:04
English, 31.03.2020 06:04
Biology, 31.03.2020 06:04
Mathematics, 31.03.2020 06:04
History, 31.03.2020 06:04