subject
Engineering, 05.11.2019 00:31 kymmyaboss2

Afuel oil is fed to a furnace and burned with 25.0% excess air. the oil contains 87.0 wt% c, 10.0% h, and 3.00% s. analysis of the furnace exhaust gas shows only n2, o2, co2, so2, and h2o. the sulfur dioxide emission rate is to be controlled by passing the exhaust gas through a scrubber in which most of the so2 is absorbed in an alkaline solution. the gases leaving the scrubber (all of the n2, o2, and co2, and some of the h2o and so2 entering the unit) pass out to a stack. the scrubber has a limited capacity, however, so that a fraction of the furnace exhaust gas must be bypassed directly to the stack. at one point during the operation of the process, the scrubber removes 90.0% of the so2 in the gas fed to it, and the combined stack gas contains 634.5 ppm (parts per million) so2 on a dry basis; that is, every million moles of dry stack gas (i. e. not including the water) contains 634.5 moles of so2. we wish to calculate the fraction of the exhaust bypassing the scrubber at that moment.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 14:10
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
question
Engineering, 04.07.2019 18:10
Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.
Answers: 2
You know the right answer?
Afuel oil is fed to a furnace and burned with 25.0% excess air. the oil contains 87.0 wt% c, 10.0% h...
Questions
question
Mathematics, 03.06.2020 19:09
question
English, 03.06.2020 19:09
question
Mathematics, 03.06.2020 19:09
question
Mathematics, 03.06.2020 19:09
question
Mathematics, 03.06.2020 19:09
Questions on the website: 13722361