Engineering, 04.11.2019 22:31 Irenesmarie8493

A12ka lightning bolt strikes an object for 15 μs. consider the following: a. how much charge is deposited on the object? b. how many electrons is this? (for comparison, there are approximately 1028 electrons in the human body.) c. if the lightning strike discharges across a voltage potential of 250 million volts, what is the lightning bolt’s power? (is this more or less than 1.21 gigawatts? ) d. how much energy is imparted by the lightning strike? e. a typical cell phone battery has a charged capacity of 1800 mah at 3.7 v. if the energy from the lightning strike were harnessed, how many cell phone batteries could be fully charged using this energy?

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 19:30

When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

You know the right answer?

A12ka lightning bolt strikes an object for 15 μs. consider the following: a. how much charge is dep...

Questions