Engineering, 01.11.2019 05:31 judyandaub1

Consider fe – 3.0 wt% c steel at a temperature just below the eutectic point. determine the phase present in this alloy. determine the compositions of each phase. determine the relative amount of each phase. determine the relative amount of lamellar structure. determine the relative amount of lamellar structure.

(e) consider 10 kg of fe – 1.0 wt% c steel at 1200°c. how much pure iron pellets should be added to this steel to have pearlite only in its microstructure when the temperature is decreased below the eutectoid point slowly?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

Answer

Engineering, 04.07.2019 18:20

A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Plan an experiment to measure the surface tension of a liquid similar to water. if necessary, review the ncfmf video surface tension for ideas. which method would be most suitable for use in an undergraduate laboratory? what experimental precision could be expected?

Answers: 2

Answer

You know the right answer?

Consider fe – 3.0 wt% c steel at a temperature just below the eutectic point. determine the phase pr...

Questions